Ok, I tried 11.0.4.3 and 11.0.4.8. The first one has the same problem as 10.2.1.7. 11.0.4.8 creates a file that fits. It took me 7 tries @ 1 hour each to get the bit rate right so that it fit the disk. There seems to be no consistency to what bit rate is right for the size. It certainly does not create a file of the size DVDFab says it will... not even close. DVDFab estimated a file size of 40GB @ 31750. The output was actually 46GB
I uninstalled 10.2.1.7, installed the new 11.0.4.3 and imaged the PC. Then uninstalled 11.0.4.3 and installed 11.0.4.8 and re-imaged the PC. So now when I am forced to use v11 I can restore my PC from the image with v11 on it, create the MKV and the restore my PC to v10. This way I never have two versions installed on my system at the same time. Hopefully I won't be forced to use v11 again until you get all the bugs sorted.
While I was testing I came across the following;
1. 11.0.4.8 stops responding for 20 seconds after selecting the file to open. If you click on the program it will crash. On one occasion it caused a BSOD.
2. When clicking start I'm told there is no information for the movie. I tick 'Do not show this again' and click cancel (The other option I do not want to use). EVERY time I start a new job this window is displayed and I tick again 'Do not show...". DVDFab ignores the selection.
3. Without being specific, the UI is getting worse with each new version. The main screen is now an advertising platform... really? Not good.
4. When a file already exists I am asked replace or keep both. IIRC on v10 I could say remember my choice, but in v11 I can't. Doesn't matter, because in v10 the option doesn't work anyway, if I remember correctly.
5. What is all the traffic DVDFab is sending? 11 different IPs addresses. I get that one might be an update check, but this data is virtually a continuous stream of outbound data according to wire shark
