Leroy_Cashmere Tried to rip a copy of Romeo and Juliet Blu Ray (1996). The rate will gradually slow and slow till it hits zero and stops at 3%. This is after I updated to the new version of DVDFab.I'm on a Macbook M1 Ventura 13.0.1Not sure if it's related but when I try to copy WALL-E it's acting weird. Shows up as "QUACK_D1_CAN" and never loads. See screenshot. Had to force quit DVDFab each time.Both Blu Rays are from Netflix if that's important.Sorry not very computer savvy. Tried to attach the log file but it was too big. Couldn't figure out a way to edit the file to trim it down so I dumped it in Word.Thanks for any help!-R
Mona Log file can't add it to the original post for some reason.riggstrIf using Blu-ray Copy - Main Movie or Full Disc mode to make a 1:1 copy, can it work?
Leroy_Cashmere Sorry I'm not sure what Main Movie or Full Disc mode is. Here are some screenshots of my settings.Thanks for your help Mona!
Leroy_Cashmere I am so sorry Mona, I posted this topic in the wrong forum. I'm using Blu Ray Ripper.Should I make a new thread over there?Thanks again for your prompt help.
Mona I am so sorry Mona, I posted this topic in the wrong forum. I'm using Blu Ray Ripper.Should I make a new thread over there?Thanks again for your prompt help.riggstrIt's Okay, will still need you to use the Copy module to have a try first;)
Leroy_Cashmere Thanks again for your help Mona. I did what you suggested and tried Blu Ray Copy using both Main Movie and Full Disc. Same issue both times, stalled out after a while.
