StreamFab for Mac 6.1.9.1 download is only for Intel. Where is the M1 version?

matthiasr

Hi DVDFAB team,

there is only the Intel version of StreamFab for Mac version 6.1.9.1 as download available.
Why is there no M1 version?

Regards,
Matthias

zardoz7434

This has been a common complaint about their Mac Version.. even when Rosetta is installed it locks up constantly.. I believe you'll have to open a support case with them to ask for M1 support.

darth_ep1

There used to be an "M1-Version". The last one I saw was named "streamfab_for_m1_6167.dmg" (dated May 2024), the filesize was 439MB. I assume they now made an "universal binary" installer for both, Intel and M1 (or M2?), because the latest installer for Mac (6.1.9.3) now counts 583MB.... (?)

matthiasr

There used to be an "M1-Version". The last one I saw was named "streamfab_for_m1_6167.dmg" (dated May 2024), the filesize was 439MB. I assume they now made an "universal binary" installer for both, Intel and M1 (or M2?), because the latest installer for Mac (6.1.9.3) now counts 583MB.... (?)
darth_ep1

One could think so, but that's not the case.
I've just downloaded the current version and checked. It is still just an Intel build and not a universal build.

darth_ep1

I've just downloaded the current version and checked. It is still just an Intel build and not a universal build.

ok..... :eek: Thanks for the insight.

so where did the "streamfab_for_m1" Versions disappear to (and why)? :o

Good question, Matthias.

anyone any clue?