Announcement

**maineman** · 05-26-2010, 04:02 PM

Unless you just have really bad luck and have a bad verb, I'd say there's a good chance your burner is dying.
Generally this type of error is either crappy media or the burner just can't set the proper power to burn the disc.
You can try one more verb, but I doubt it was a bad disc...you'll have to burn another to see for sure.

By the looks of things, this burner is old...circa 2005 and the firmware is from 2007 and probably the most recent,
although i haven't really looked around.

Have you burned DL media successfully with this burner previously?

**GoingYard** · 05-26-2010, 04:55 PM

Thanks for quick reply.

I have been burning all the single layer disc's no problem.

Avatar has been my first attempt at DL. I have just tried two things on the second Verbatim...lower write to 1x and tried this solution too...from searching the web.

•Disable IMAPI Service (Work's in most cases):
1.Launch Control Panel -> Administrative Tools -> Services .
2.Browse for "IMAPI CD-Burning COM Service", Right-click on it and select properties.
3.Change Startup Type to Disabled.

SUCCESS AT BURN.....WHICH ONE WAS IT???

**Gummigutta** · 05-26-2010, 10:27 PM

Lowest speed is 2.4x. Perhaps try one of the faster speeds.

(Speeds: 2.4x, 4x, 6x, 8x)

**signals** · 05-26-2010, 11:30 PM

I recommend 4X or below for the 001s. Try enabling OPC in ImgBurn if the drive supports it.

**CBR929** · 05-27-2010, 01:55 AM

GoingYard
If I also my add if burning DVD+R make sure to set book type to DVD-ROM , you can do this by opening Fab > click the green check on top > DVD / Blu-Ray > Write > near the bottom put a check in set book type to DVD-ROM and restart Fab
CBR929

Announcement

Failed Burn w/Verbatim DVD+RDL (MIS)

Failed Burn w/Verbatim DVD+RDL (MIS)

Comment

Comment

Comment

Comment

Comment