Windows 10 latest update and StreamFab latest update - now no worky

[flylow+]

Good to know. I thought I hovered over all the text and somehow missed that the x64 and x86 were hyperlinked.

Same files linked in the sticky thread: https://forum.dvdfab.cn/forum/stream...eamfab-windows

3. Download the latest offline version of StreamFab from the "Sticky" announcement at the top of the forum. Otherwise, just download directly from...
32bit version: https://www.dvdfab.cn/mlink/download...reamFab_Online
64bit version: https://www.dvdfab.cn/mlink/download...=StreamFab_x64
NEVER use the online pop-up installer as it often produces bad installs.

[tilu3303]

on the webpage, on the right half where it says "streamfab" down near the bottom where it says "download offline installer" click on x64
to download the offline installer.

Good to know. I thought I hovered over all the text and somehow missed that the x64 and x86 were hyperlinked.

[tilu3303]

Thanks for the tip, but I don't see a link to the offline installer when I follow that link.

The setup file that downloaded said "online" in it, but running it did a download of the full program. When it was completed the program ran without error. The only issue so far is that that it didn't find all the downloads I had queued up and not run yet.

[october262]

Thanks for the tip, but I don't see a link to the offline installer when I follow that link.

on the webpage, on the right half where it says "streamfab" down near the bottom where it says "download offline installer" click on x64
to download the offline installer.

[flylow+]

See How to do a clean install of StreamFab (Windows) https://forum.dvdfab.cn/forum/stream...eamfab-windows

[tilu3303]

did you update via the built in installer or the offline installer ??
try installing streamfab using the offline installer - https://www.dvdfab.cn/download.htm?ad=forum_nav
and see if the error persists.

Thanks for the tip, but I don't see a link to the offline installer when I follow that link.

[october262]

I just restarted Windows 10 for the latest update and when restarting I was encouraged to update StreamFab. Now each time StreamFab tries to start I get the following error window:

StreamFab64 - Entry Point Not Found
The procedure entry point cef_resolve_url could not be
located in the dynamic link library C:\Program Files\StreamFab\StreamFab\StreamFab64.exe.

Two restarts later and StreamFab still will not start.

did you update via the built in installer or the offline installer ??
try installing streamfab using the offline installer - https://www.dvdfab.cn/download.htm?ad=forum_nav
and see if the error persists.

[tilu3303]

I just restarted Windows 10 for the latest update and when restarting I was encouraged to update StreamFab. Now each time StreamFab tries to start I get the following error window:

StreamFab64 - Entry Point Not Found
The procedure entry point cef_resolve_url could not be
located in the dynamic link library C:\Program Files\StreamFab\StreamFab\StreamFab64.exe.

Two restarts later and StreamFab still will not start.