When DVDFab started, it saw the disk and showed the Volume name and started its scanning. After a long period of time, It poped up a dialog box saying that I had to be connected to the internet. Wrong, since I am connected to the internet.
So, I clicked OK. Instead of DVDFab trying to connect, it just gave up.
I then manually selected the media and instead of showing the disc volume name after the drive letter, it just showed the drive letter. After 15 + minutes of this nonsense, I quit DVDFab and started over. After ~10 minutes, it finally got it right.
So, there are two problems with this release:
1: The no internet connection dialog box needs an additional selection: Try Again
2: Find out why a manual selection of the media, after the above situation, does not seem to even attempt to read the media. It just goes off into la-la land.
So, I clicked OK. Instead of DVDFab trying to connect, it just gave up.
I then manually selected the media and instead of showing the disc volume name after the drive letter, it just showed the drive letter. After 15 + minutes of this nonsense, I quit DVDFab and started over. After ~10 minutes, it finally got it right.
So, there are two problems with this release:
1: The no internet connection dialog box needs an additional selection: Try Again
2: Find out why a manual selection of the media, after the above situation, does not seem to even attempt to read the media. It just goes off into la-la land.