Help! Blu-Ray Clone Operation Failed

[mcauliff]

I attempted to perform a Blu-Ray Clone of a movie. I have Version 10.0.8.7 64 bit. I used Verbatim BD-R DL media for output.

The operation failed before completion. It appears the movie was copied, but the menu was not operational. In watching the movie it froze about half way through. I usually copy DVDs, but this is the first time doing Blu-Ray.

Her is the log

Burn Iso 2018-03-30 13:07:35 --------------------------------------------------

13:07:35 Info IsoFile: C:/Users/Michael/AppData/Local/Temp/Documents/DVDFab10/Temp/Clone/THE_LAST_JEDI/THE_LAST_JEDI.iso
13:07:35 Info WriteMode: 4
13:07:35 Info LayerBreak: 0
13:07:35 Info Lock media
13:07:35 Info MediaType: 16
13:07:35 Info Capacity: 47732 MB
13:07:35 Info Operation Started!
13:07:35 Info Source File Size: 45056 MB
13:08:01 Info Writing LeadIn...
13:08:01 Info Write started 23068672 sectors to write
14:30:44 Info Failed to Write Sectors 21317504 - 21317535 - Invalid Address For Write
14:30:44 Info Closing Track...
14:30:49 Info Finalising Disc...
14:31:04 Info Unlock media
14:31:10 Info Eject8
14:31:10 Info Duration: 01:23:29
14:31:10 Info Operation Failed!
14:31:11 Info Unlock device
14:31:11 Info Close device
14:52:13 Info SetWriter(G, 0)
14:52:13 Info SetDoNotAutoEjectDisc(0)
14:52:27 Info Open device
14:52:27 Info Lock device
14:52:27 Info MediaType: 14
15:26:00 Info Input Speed is: 11080, Output Speed: 11080
15:26:00 Info StartPerf Speed: 6320, EndPerf Speed: 11080




What is the best method to copy all of a Blu-Ray movie?

What is the proper media to use?

Any other suggestions?

[LaciBacsi]

I have had numerous problems using Verbatim BD-R DLs (single layers work just fine). My problems is usually at the layer break. The discs burn and verify correctly with Imgburn using my LG WH14NS40 burner and play fine on PC software player, but tend to stutter (or freeze) at the layer break and beyond (i.e. when reading the second layer) when played on my stand alone BD player (Sony BDP S6500) . Based on your log, it appears that the error appeared well beyond the layer break and closer to the inner tracks of the second layer.

I would suggest burning at the slowest speed that your drive supports for DL (likely 2x) and see if you get better results. (And of course, the usual recommendation of making sure you have the latest firmware for your burner.) LG recommends Panasonic DL media for my burner, but those are hard to come by and are much more expensive than verbatim DLs.