DVDFAB-Error when burn DVD

[Tanktuw]

When burning DVD file to DVD the first time in FAB all works fine, but the following burn gives the following error. Task_1 failed! Error=100. If I reboot my laptop then I can burn another, and again the error on the second burn.

OS W7

[GregiBoy]

Your laptop drive is most probably getting too hot as they usually do. You are lucky to get even one burn with a laptop drive.

[Tanktuw]

Error 100

I have used this product for years and never had trouble with multiple burns. I have to do is perform a reboot and everything works again...one time.

[AGJ]

Thread moved to DVD section

[wtxgringo]

that sounds like a raid array error for your drive, correct? if so, could be just a bad disk. just had the same prob with a blu ray movie yesterday, same error & no copy...
Edited by mm .

[maineman]

Observance of Copyright Laws in the DVDFab Forums --------------------------------------------------------------------------------

The owners of this forum and suppliers of the software discussed here do not support or condone the theft of intellectual property in any fashion, but believe that consumers that purchase entertainment media products have the Fair Use right to 1) make a single backup copy for security purposes and 2) convert the content to a form more suitable or convenient than that in which it was supplied. Discussion of other use of the software that infringes on the rights of the copyright holder will not be permitted, including specifically but not limited to copying rental DVDs or games or copying any content that the user does not personally own. This is an International forum and copyright laws vary from country to country. The user of the software bears sole responsibility for its use in compliance with local laws.

Copyright 2009 Fengtao Software, Inc.

that sounds like a raid array error for your drive, correct? if so, could be just a bad disk. just had the same prob with a blu ray movie yesterday, same error & no copy... Edited by mm...

This is your second warning re: copyright laws and Fair Use provision...
in as many days.
I would strongly suggest that you do not force a third.

[barilenator]

Just use this product for its intended purpose as stated in the copy right laws,and all will go nicely with out as many error messages, or non at all. This product is the best on the block and should be used within the laws of the copy right kingdom. Lets keep it rocking!!