Foxcatcher

[sleeper1428]

Using the latest version (9.1.9.2) the DVD would not copy with PathPlayer enabled. Tried a second time with PathPlayer disabled and again the disc would not copy. Finally I set PathPlayer to 'Enable only as needed' and with this setting the disc copied just fine.

Anybody else run into this problem?

[sleeper1428]

Further info on copying Foxcatcher

I decided to run another set of tests on the DVD Foxcatcher and the results were interesting. The first test was to attempt to do a Full Disc copy with PathPlayer Enabled. Just as in my first reported test this one failed, the copy hanging at 1% completed - I cancelled after a full minute when the copy had not progressed beyond 1%. The second test was to attempt the same copy but this time with PathPlayer Disabled. Unlike my first report, this time the copy worked fine and was completed in less than 15 minutes. Wanting to be complete, I then did a third copy, this time with PathPlayer set to Enable PathPlayer as Necessary. And just as in my original report, this copy worked just fine, completing in almost the same time as the copy made with PathPlayer Disabled.

As in my original report, I used version 9.1.9.2 of the US version of DVDFAB and this time I've included - as attached files - the internal log reports for each of these tests. They are clearly labelled so you can identify which file is related to which of the three test copies I've described above.

Hope this helps to figure out the problem with this particular DVD and what can be done to avoid this problem in the future.

sleeper1428