Wind River "Not enough space" error

[zapt]

Here you go. Since the burn attempt was yesterday(2/26/18), I assume only the first part of this log file is relevant. Thanks!

[october262]

please post the dvdfab internal log files as well as the burn log files.

[zapt]

Those were all checked. I don't typically change anything other than the setting for Drives > DVD Write. It's set for 4488 (DVD-R), which I believe is the default in DVDFab 10.

[october262]

click common settings - dvd - pathplayer and make sure that pathplayer is set to "always enabled "
then click "dvd protection " and check enable cloud decryption service is checked.
restart dvdfab and retry the original store bought disc again and see if it is still too big to fit on the blank disc.
also try going into the general settings area and click on the factory default settings button in the lower left corner.

[zapt]

I've never seen this before, so I assume it's a 10.0.8.1 issue. Although DVDFab said it was going to compress to 77%, it checked the blank (Verbatim 95079), decided it was ever so slightly too small, and then failed by writing nothing. When looking at other log entries, it appears that sometimes it judged the blank's capacity as 4488 MB and others as 4489 MB (even though they're all the same manufacturer and lot). Any idea what's going on? This has happened at least one other time, too, I believe.