DVD Ripper Titanic Artifacts and Audio Desynchronised

[lzk87]

Hello! last beta, i try to rip my Titanic original DVD to MKV (profile: mkv remux) and the job was done (only in software accelleration, dxva cause freeze..) but the audio is desynchronised respect the video.. and at the half of the movie i get some artifacts (about 2/3 minute)..

DVD Info

Info for drive [E:\] (DVDFab 8.0.7.8)
Vendor: HL-DT-ST
Product: BD-RE BH10LS30
Revision: 1.00
Vendor specific:
Drive region control: RPC II
Drive region: 2
User changes left: 0
Vendor resets left: 4
AACS version: 1
Number of concurrent AGIDs: 1
Supports bus encryption: NO
Supports binding nonce generation: YES

Disc media: DVD
Disc type: DVD-Video
Disc region: 2
Volume name: TITANIC_PAL_DISC4
Video standard: PAL
Layer 0 size: 2042016 sectors (3988 MBytes)
Layer 1 size: 2042016 sectors (3988 MBytes)

CSS (Content Scramble System) protection is removed!
RC (Region Code) protection is removed!
RCE (Region Code Enhancement) protection is not found.
APS (Analog Protection System) protection is removed!
UOPs (User Operation Prohibitions) protection is removed!

Invalid PTTs protection is not found.
Invalid PGCIs protection is not found.
Invalid PGCs protection is not found.
Invalid TMAPs protection is not found.
Invalid CELLs protection is not found.
Invalid VOBUs protection is not found.
Fake vts protection is not found!
Bad sector protection is not found!
Structure protection (ARccOS, RipGuard, etc.) is not found.

PathPlayer is enabled!
Unplayable cell is not found.

I upload more DVD Info from DVDFab here : http://www.megaupload.com/?d=TIPG1OGX

thank you support..

[AGJ]

Try it with out using Lightning-Recoding to see if that helps with the Audio sync

[lzk87]

same problem with the "software" mode, (no Lightning-Recoding or DXVA activated)..

[lzk87]

same issue with 8.0.8.5 ...

[GregiBoy]

Try it setting the frame rate to 25fps, not same as source and report results back here...

[lzk87]

mkv remux don't allow to set a different frame/sec ....

[Anny]

mkv remux don't allow to set a different frame/sec ....

Hi lzk87,

1) As you know, if you use "mkv.remux" profile, there would be no compression involved and the output file would be with original aspect ratio, original bitrate, etc. That is why you could not change framerate.

2) Have you tried using other profiles(such as "mkv.h264.audiocopy")? If not, give it a try and see the result.

Anny

[lzk87]

last beta "qt version" 8.0.8.7 the problem still remain ...

@Anny: i need the mkv remux for "untoched" movie from my dvd.. the other option for me in this case are useless.. anyway thank you for your reply ..

[lzk87]

oh yes last beta FINALLY this problem is fixed ver. 8.0.8.9 .. very good DVDFab team!