DVD Ripper Audio Sync - Bourne Identity

[1chabs]

I’m a new user so I’m sorry if this is a lame question. Using the trial version to test the software and I tried Bourne Identity as a first go –round. I’ve tried it with the standard setting and then with a higher resolution (stats below), and then lastly using "software" for the codec; on all cases the audio is out of sync. This second/third time was better, only off by about 3 seconds but it’s still unwatchable. Is this a common issue or is it something with Bourne Identity specifically? Thanks in advance for your help.


DVDFab 8.0.8.5 (2011/03/22 12:21:27)

0m 01.38s: option dvd2dvd 1 dvd2mobile 1 bluray2bluray 1 bd2mobile 1 bd23d 1 bd2dvd 1 file2mobile 1 filemover 1
0m 10.24s: detected dvd
0m 10.35s: drive E
0m 10.35s: dvd type 1
0m 10.35s: volume label THE_BOURNE_IDENTITY
0m 13.86s: got copyright 1 fe
0m 14.83s: got udf/iso
0m 17.28s: got discinfo
0m 17.30s: pathplayer enabled
0m 17.48s: no main title, turn off pathplayer


DVDFab 8.0.8.5 (2011/03/22 13:25:03)

0m 00.15s: option dvd2dvd 1 dvd2mobile 1 bluray2bluray 1 bd2mobile 1 bd23d 1 bd2dvd 1 file2mobile 1 filemover 1
0m 07.36s: detected dvd
0m 07.45s: drive E
0m 07.47s: dvd type 1
0m 07.47s: volume label THE_BOURNE_IDENTITY
0m 09.48s: got copyright 1 fe
0m 10.03s: got udf/iso
0m 11.85s: got discinfo
0m 11.85s: pathplayer enabled
0m 36.25s: got dvdinfo
0m 36.41s: opened dvd
4m 13.56s:


------ begin mobile work(1/1) ------


4m 13.56s: create config(0)
4m 13.58s: convert profile(ipad.default)
4m 16.40s: dvd title(1) angle(0) chapter(1->21)
4m 16.40s: stream(480,2,1) stream(128,86019,1) stream(32,94208,4)
4m 16.43s: not set correct fourcc for video(28)
4m 16.43s: info: set output video frame_rate(24000/1001)
4m 16.46s: subpicture preset(1), mode(0)
4m 17.79s: h264_encode: encode param profile(1) level(41) bitrate(7457)
4m 23.92s: subpicture(32) mode(0)
4m 23.93s: connect to sub render filter
4m 30.58s: display only forced subs now 085m 33.15s:

[mike98020]

Look at the thread in this forum with the title "Audio Off Synch throughout the entire movie", look at the last message in that thread and try those settings.

Mike.

[1chabs]

Thanks!

Audio is syched up well. I will increase the rate a little one more time as the PQ dropped a little, but having the words come out of the mouths when the lips move is a very good thing! So annoying follow up...are these manual settings something recommended for ALL rips or this was a disc problem, and typically the standard settings will work (aka this was just a specific hack for Bourne)...I'm assuming the former? Thanks again.

[mike98020]

Not a Boune Identity issue. I would use these settings for all DVDs.

Mike.

[sunny]

Hi 1chabs, Please do a capture of the Conversion Settings window that will offer visible parametes you set for ipad.default.

[1chabs]

Rips to iPad

You requested the specs, but I've abandoned this approach. Reading other threads in this forum, I tried using the "Convert to AppleTV" rather than "to iPad" with EXEMPLARY results. Using the iPad specs (once I got them to work) the rip was ok but iTunes wouldn't let me sync to the iPad. Using AppleTv, every rip has been perfect and I didn't need to make any adjustments; and the big thing is all syncs went fine. Oh and the rip times are 25% that of the last "iPad" spec I used. If you're ripping for iPad, iPod or iPhone I highly recommend using the AppleTV parameters...