dvd to mobile complications

[90312]

Sandes, I just did X men origins in generic.avi.divx.audiocopy in 9 minutes 21 seconnds, keeping in mind I use 320x240 resolution or close to it for my device, large frame resolution will take longer. Again A/V sync is perfect start to finish.

[sandes]

generic.avi.xvid doesn't work either!

[GregiBoy]

No, I always use generic.avi.xvid.audiocopy as I feel it gives better results.

[sandes]

I just tried again with no avail. GregiBoy and 90312 did you both try the profile [B]generic.avi.divx.audiocop, because that is what I am trying and it still doesn't work. For Mp3 the estimated completion time starts at 4 hours and starts gaining quickly, so I didn't even bother attempting from my hard disk file.

[GregiBoy]

Right click on the Fab icon, "Run as Administrator"

[sandes]

I'll try converting from my hard disk folder. I have been going direct from dvd thus far. I don't know if I am running it as the Administrator or not. I don't see where I would choose that option?
Thanks for the support.

[GregiBoy]

I have just tried generic.avi.xvid.audiocopy also and same as 90312 have had no problems and audio is in sync. The process took just under an hour, 2 pass, for a 2 hr 15 minute movie.

A question though? Are you runnning DVD->Mobile direct on the original movie DVD or from a ripped hard disk folder?

Always use the hard disk folder as problems can occur direct from DVD.

When you are running Fab, are you running it as Administrator? Please try this and maybe we can track down what the heck is causing this.

[90312]

I tried both of the audio trials. audiocopy completed in 11:20, the mp3 took a little longer @ 14:08. Movie is Wolverine that new X men flick. Both profiles completed and the A/V sync is spot on perfect. Something is amiss sandes!

[sandes]

I just tried the audiocopy again. It starts out running much faster, but it doesn't finish at all. It stops at about 30% with a window from dvdfab asking for a damage report.

[signals]

I think you will find that any audiocopy profile will run much faster, but the MP3 should be running much faster than the times you are reporting. I just installed v6.0.7.0, but have not had time to do a conversion with any of hte MP3 profiles yet. Perhaps someone else has.

[sandes]

I am using v6.0.7.0. Yesterday I attempted again using the generic avi.divx.mp3. It took over 15 hours to get it on my computer. The video transferred and works fine on my device, but the audio isn't functioning properly. Low and choppy. Maybe I should try the avi.divx.audiocopy, I am confused as to what codec that is, or is there some other audio setting I don't know about. What is the estimated time of converting 3 hours of video. 15 hours is rediculous.

[signals]

I am using the generic profile. Crashes everytime around 30% completion.

Please install v6.0.7.0 and try it. Other similar problems were corrected in the new release, hope your was also. Please post the results you get after the new install.

[90312]

All of these profiles are under the general heading of "Generic", maybe I could help if I know which one you are attempting.

[sandes]

I am using the generic profile. Crashes everytime around 30% completion.

[90312]

I've tried 6.0.7.0 with the PSP profile that was broken and it works fine, good A/V sync too, the thumbnail is still busted! The problem with it slowing to zero fps is fixed as far as I can tell.

sandes, what exact profile are you trying in generic and I'll give it a shot.