2D to 3D does not work

[molitar]

I have tried to take an mp4 file 2D only a few minutes in size and convert to 3D.. it gets to 100% than just sits their showing encoding with no progress on task time left and the timer just counting away.

DVDFab 8.1.2.5 (2011/09/30 16:46:36)

0m 00.99s: Qt Translator file load success
0m 01.04s: option dvd2dvd 1 dvd2mobile 1 bluray2bluray 1 bd2mobile 1 bd23d 1 bd2dvd 1 file2mobile 1 filemover 1
3m 01.25s:


------ begin mobile work(1/1) ------


3m 01.25s: info: create config(3)
3m 01.25s: info: convert profile(fujifilm.3DV1.avi.mjpeg.mp3)
3m 01.25s: info: file (.mp4),3D(2)
3m 01.25s: info: streams((0.2)(1.2))
3m 01.28s: info: not set correct fourcc for video(8)
3m 01.28s: info: set output video frame_rate(30000/1001)
3m 01.28s: try to use gpu acceleration(2) for video decoding
3m 01.28s: DXVA GPU acceleration for video decoding enabled
3m 01.28s: info: enable 2D to 3D advanced mode!
3m 01.30s: info: open 2D to 3D option(gain:4, visual_depth:254) successful !
9m 02.93s: ------ cancel all mobile work -------
10m 03.70s:


------ begin mobile work(1/1) ------


10m 03.70s: info: create config(3)
10m 03.70s: info: convert profile(HTC.EVO.3D.h264.aac)
10m 03.70s: info: file (.mp4),3D(2)
10m 03.70s: info: streams((0.2)(1.2))
10m 03.73s: info: not set correct fourcc for video(28)
10m 03.73s: info: set output video frame_rate(959/40)
10m 03.75s: try to use gpu acceleration(2) for video decoding
10m 03.75s: DXVA GPU acceleration for video decoding enabled
10m 03.75s: info: enable 2D to 3D advanced mode!
10m 03.75s: info: open 2D to 3D option(gain:4, visual_depth:254) successful !
10m 05.28s: info: h264_encode: encode param profile(1) level(31) bitrate(2333)

[CBR929]

Hi molitar

Open Fab click the Click the Green √ at top right corner of the DVDFab screen, and open Common Settings > General >A/V Codec, put a check in Disable all GPU codes and make sure they are set to Software, restart Fab and try again.
CBR929

[molitar]

Ok tried that... no luck.. The file is a mp4 71 megs in size and 5 1/2 minutes long. But at 27% rendering the file drop from 30+ fps and continually get slower until it's fps has dropped to nil. If I cancel rendering than I have 1.35 minutes of video that is fully watchable.