Issues converting mpg files to iphone compatible ones

[bigbwb]

Hey guys,
I have tons of Blu ray rips I converted into mpg's on my HD. They were originally ripped in Fab into MKV files then I used an outside program to convert them to mpg files to stream on my ps3.

I recently tried taking these mpg files (they do contain 5.1 PCM lossless sound) using Fab video converter and change them into the iphone4 compatible file. The process starts and hangs after about 2%?

Thoughts?

[bigbwb]

I tried using only "software" for video encoding, still no luck. Every option hangs at around 2.1%?

Logs:
------ begin mobile work(1/1) ------


2m 47.46s: create config(3)
2m 47.46s: convert profile(generic.mp4.h264.aac)
2m 47.50s: 513.05 : the video size is not the same 0x0 -> 1680x698
2m 47.50s: 513.05: get video start offset(54011260)
2m 47.50s: 2m 47.50s: info: set output video frame_rate(959/40)
2m 47.56s: try to use gpu acceleration(1) for video decoding
2m 47.56s: CUDA GPU acceleration for video decoding enabled
2m 47.57s: h264 encode: using official CUDA encoder
2m 47.62s: h264_encode: encode param profile(1) level(20) bitrate(598)
5m 39.00s: ------ cancel all mobile work -------
8m 37.35s:


------ begin mobile work(1/1) ------


8m 37.35s: create config(3)
8m 37.35s: convert profile(iPhone4.h264)
8m 37.39s: 513.05 : the video size is not the same 0x0 -> 1680x698
8m 37.39s: 513.05: get video start offset(54011260)
8m 37.39s: 8m 37.40s: not set correct fourcc for video(28)
8m 37.40s: info: set output video frame_rate(24000/1001)
8m 37.45s: try to use gpu acceleration(1) for video decoding
8m 37.45s: CUDA GPU acceleration for video decoding enabled
8m 38.53s: h264_encode: encode param profile(1) level(31) bitrate(717)

[bigbwb]

I guess I am just a bit dissapointed and frustrated that the converter feature that I just bought a week or so ago does not work as advertised? If I am doing something incorrectly,then its my fault. The info says it converts mpg files and is compatible with iphones, so I dont see the issue?

Venting complete

[CBR929]

Hi bigbwb

Open Fab click the Click the Green √ at top right corner of the DVDFab screen, and open Common Settings > General >A/V Codec, put a check in Disable all GPU codes and make sure they are set to Software, restart Fab and try again.
CBR929

[bigbwb]

Hi bigbwb

Open Fab click the Click the Green √ at top right corner of the DVDFab screen, and open Common Settings > General >A/V Codec, put a check in Disable all GPU codes and make sure they are set to Software, restart Fab and try again.
CBR929

Ill give it a try, thanks!