Blu-ray DVDFab Blu-ray and UHD After Editor Needs further development to replace Dolby Atmos

[ACLA2016]

Good morning,

I was trying to evaluate the purchase of BD and UHD After Editor, and when I tried it I saw that I didn't have the option to replace the audio with Dolby Atmos. Is this so? Will they move forward to include these, please tell me.

Because it is important to me that it also allows the replacement in this format.




Thank you very much

[Mona]

It's the same as other audios. Please refer to the image attached to the post and have a try.

[ACLA2016]

Hi Mona,
The problem is that when I try to load a Dolby Atmos audio from the folder where I have it, it doesn't find it. If it finds the DTS, DTS-HD, the Dolby Digital Plus, they must have the eac3 extension, if not, it doesn't play them either, but the Dolby Atmos extension is true+ac3, and as I say, it doesn't play them, so I can't load them.

Regards

[ACLA2016]

Hi Mona,
We have been able to look into this and move forward.

Thanks

[Mona]

Hi Mona,
We have been able to look into this and move forward.

Thanks

Hi. The issue you reported is awaiting investigation by the developers.

[ACLA2016]

Good Mona,
Yesterday I carried out a test with a Dolby Atmos, replacing the .thd+ac3 extension with .thd and it allows you to view it when loading it in the montage, and the final result is ok, since the Atmos embedded generates it again automatically in the UHD.

Thank you