Version 9 vs version 8 BD scan

[drmark12pa]

I'm just now trying version 9 software and have yet to get used to the interface.
A few questions:
1) why when I select Main Movie only do I see the percentage bar for the scanning in version 8 but only see the size of the movie fluctuate in version 9? I don't know when it's safe to start copying in version 9
2) what is the difference between functionality of version 8 vs. version 9? I'm used to the version 8 interface and as long as it copies perfectly why switch to version 9? I feel version 8 is more flexible in checking/unchecking options but then again it may be that I'm more used to it.

[GregiBoy]

The reason to swap to Version 9 is that Version 8 will no longer be updated so any new copy protection/new titles may not be able to be handled by Version 8.

[glenns]

You can use version 9 to take the copy guard out and make a iso to hard drive then use version 8 to do the conversion if you have problems with version 9.

[drmark12pa]

Scanning percentage

How do I know when it's safe to hit the START button for a MOVIE ONLY copy in version 9 software? I see the size of the rip fluctuate for some time. In version 8, the scanning bar at the bottom of the screen showed a percentage so I knew when it was apparently safe to start copying.

[Minesh]

How do I know when it's safe to hit the START button for a MOVIE ONLY copy in version 9 software? I see the size of the rip fluctuate for some time. In version 8, the scanning bar at the bottom of the screen showed a percentage so I knew when it was apparently safe to start copying.

it is tricky. I check LED light of my blu ray drive. I wait for LED light to goes off after few minutes. You can also notice disc stop spinning completly. When LED is turned off then I start copy main movie. So far I don't have any problem.