Chaplin at Keystone Disc 4 - Problem ripping two titles

[signals]

It also shows an error in the mkv creation process. The devs will check it. In the meantime, I suggest the following:
1) Start DVDFab and disable dvd cloud decryption in Settings
2) Use DVD Customize mode to copy only the episode you are having a problem with and write it to a folder not an iso. See if it plays with Fab Player 6 or VLC. If it plays, do 3).
3) Try that as a Source for Ripper. If it fails in Passthrough, try one of the re-encode modes.

[captnvideo]

I decided to start the entire process over from the beginning. I deleted the log file and used DVDCopy > Clone to create the ISO. It only took 14:45 minutes. Then I immediately went to the Ripper, loaded the ISO, selected the problem Title (Title 4) and attempted to rip to MKV. It will not rip. After two minutes, it showed .10 MB/s and 0% completed. I cancelled the job and exited from DVDFab. Attached is the log. Hope this [ATTACH]n385588[/ATTACH] helps. Thank you so much for your support.

Sorry I did not exit DVDFab. Here is the complete log file. Please ignore the previous one. The only error I see is > error curl get: Failure when receiving data from the peer.

dvdfab_internal.log

[captnvideo]

Use Notepad to open the file, copy and paste the log session to a new pure text document (not Word doc) and attach the new .txt file to the post using the instruction provided in your other thread. You can then flush the log by deleting it, DVDFab will make a new one the next time you open it.

I decided to start the entire process over from the beginning. I deleted the log file and used DVDCopy > Clone to create the ISO. It only took 14:45 minutes. Then I immediately went to the Ripper, loaded the ISO, selected the problem Title (Title 4) and attempted to rip to MKV. It will not rip. After two minutes, it showed .10 MB/s and 0% completed. I cancelled the job and exited from DVDFab. Attached is the log. Hope this dvdfab_internal.log helps. Thank you so much for your support.

[signals]

Use Notepad to open the file, copy and paste the log session to a new pure text document (not Word doc) and attach the new .txt file to the post using the instruction provided in your other thread. You can then flush the log by deleting it, DVDFab will make a new one the next time you open it.

[captnvideo]

No, you should attach the logs for Disc 4, it may have different protection that the developers need to check.

The log file is cumulative and huge. Unable to upload it as is. Should I delete it and start over?

[signals]

No, you should attach the logs for Disc 4, it may have different protection that the developers need to check.

[captnvideo]

Chaplin at Keystone Disc 4 loads and scans without any errors. If I Clone it to ISO, all titles play perfectly in VLC Media Player.

Even though the Ripper checks the titles and does not report any errors, here is what happens with Title 2 and Title 4:

Title 2: Rips ok but on playback audio begins too soon, so there is silence near the end of the title.

Title 4: Will not rip at all. Stays at 0%.

I have ripped quite a few other DVDs since purchasing the DVDFab Ripper license and have had no problems.

Note that I ripped all titles from Chaplin at Keystone Discs 1, 2 and 3 with no problems.

I am perplexed about Disc 4 having a problem with these two titles.

Anyone have an idea or should I just write this off as a fluke and do without ripping the two titles?

Thank you.