License/Key On upgrade, reg key did not transfer for one module

[lakemirror]

Greetings.

I have an all in one lifetime license. I recently downloaded 8163 and installed it over 8159. All went well except that my registration key did not seem to transfer for one module, DVD copy. It showed "trial" on the registration page, with 30 days remaining.

I resolved the issue myself by re-entering my registration key, all modules now show correct registration status.

No biggie, just wondered if this was a common occurrence.

Tom

[signals]

It is very unusual, but if it shows as Enabled now, it should not happen again.

[lakemirror]

The above situation occurred again, this time upon registering a new install of dvdfab on the computer I have just built. All modules registered correctly except for dvdcopy, which registered when I tried the process again.

Just fyi.

[Guest]

It happened to me with V8166, DVD Copy was listed as a trial.

I had to reinstall V8132 and then V8163 to get it to work.
g