8085 has bugs - 8073 is fine

[jhillestad]

Seems like versions past 8.0.7.3 have weird bugs... first its was the vts numbers now I have ran into another disc that causes a process fail where 8073 works just fine with the same settings (cuda on) , the disc was Paper Heart...

here is the fail from the log:

DVDFab 8.0.8.5 (2011/03/24 18:23:47)

0m 01.10s: option dvd2dvd 1 dvd2mobile 0 bluray2bluray 1 bd2mobile 1 bd23d 1 bd2dvd 1 file2mobile 0 filemover 0
0m 20.40s: got bdmv
0m 22.24s: got extended bdinfo
1m 34.72s:





------ begin mobile work(1/1) ------


1m 34.73s: create config(5)
1m 34.73s: convert profile(dvd.vob)
1m 34.73s: blu-ray playlist(3) angle(0) chapter(1->21)
1m 34.73s: stream(4113,AVC,1) stream(4352,TrueHD,1) stream(4608,PGS,8)
1m 34.77s: info: set output video frame_rate(24000/1001)
1m 34.81s: processing source(00001.m2ts)
1m 34.81s: try to use gpu acceleration(1) for video decoding
1m 34.81s: CUDA GPU acceleration for video decoding enabled
1m 34.84s: subpicture(4608) mode(1)
1m 48.65s: error: process exception, filter(type128:id25), info = 503.00 13,
1m 51.61s: ------ mobile work failed(504.00 0 error: process exception, filter(type128:id25), info = 503.00 13,

) ------

from the dvd process file :

18:25:21: Conversion: one pass
18:25:21: Source( 00001.m2ts )

18:25:21: CUDA GPU acceleration for video decoding enabled

18:25:38: Work 1 failed, Error = 504.00 0 error: process exception, filter(type128:id25), info = 503.00 13,

[cici Jia]

Hi

Please open Common Settings->General->A/V Codec, set all the video decoder options as software and set video encoder as software, then convert/copy again to see the result.

[jhillestad]

Hi

Please open Common Settings->General->A/V Codec, set all the video decoder options as software and set video encoder as software, then convert/copy again to see the result.

Did as requested , exact same failure about 20 seconds in ....

[signals]

Please post the log from the failure as well.

[jhillestad]

I thought I did post the logs , did i miss a file ?

Just a note , the failure happens when doing the conversion from either a dvdfab or anydvdhd rip to hard disk... if I convert from the blu ray itself it works! Both rips to the hard drive were full rips(BD50)... maybe its a speed issue since pulling directly from the disc would be slower.....

I always full rip the disc to the hard drive first to save wear and tear on the drive and its never been a problem and like I said 8073 works without failure on the same ripped directory.... I did send the logs like dvdfab asked after it detected the failure....

[signals]

I was referring to the failure you mentioned in post #3. I make all my conversions from files or folders on hard drive also and have very few problems. Are the failures from the bd version of the film?

[jhillestad]

yes this is the blu ray disc version of the film...