BD Ripper (3D Plus) 8.0.0.5 - CUDA decoder not working / Out of Sync

[Lord-D]

So I tested again my copy of Star Trek with new version of DVDFab.
Well, CUDA as video decoder don't work, got an error when start ripping:


DVDFab 8.0.0.5 (2010/08/26 17:32:07)

0m 00.26s: option dvd2dvd 1 dvd2mobile 1 bluray2bluray 1 bd2mobile 1 file2mobile 1 filemover 1
0m 48.57s: detected blu-ray
0m 48.57s: iso H:\Star Trek.iso
0m 48.57s: blu-ray type 1
0m 48.57s: volume label STARTREK11D1EU
0m 48.59s: root 3D0595D4________STARTREK11D1EU:STARTREK11D1EU:STAR TREK11D1EU:STARTREK11D1EU
0m 48.59s: aacs 0 bd+ 0
0m 48.59s: got discinfo
0m 48.61s: got bdmv
0m 48.64s: got extended bdinfo
1m 15.75s:


------ begin mobile work(1/1) ------


1m 15.75s: create config(5)
1m 15.75s: convert profile(mkv.h264.audiocopy)
1m 15.75s: blu-ray playlist(0) angle(0) chapter(1->16)
1m 15.75s: stream(4113,AVC,1) stream(4352,AC3,0) stream(4608,PGS,8) stream(4609,PGS,8) stream(4610,PGS,8)
1m 15.77s: subpicture preset(2), mode(2)
1m 15.77s: subpicture preset(2), mode(2)
1m 15.77s: subpicture preset(2), mode(2)
1m 15.80s: processing source(00000.m2ts)
1m 15.80s: try to use gpu acceleration(1) for video decoding
1m 15.80s: CUDA GPU acceleration for video decoding enabled
1m 16.86s: h264_encode: encode param profile(2) level(51) bitrate(14999)
1m 18.87s: subpicture(4608) mode(2)
1m 18.87s: subpicture(4609) mode(2)
1m 18.87s: subpicture(4610) mode(2)
1m 20.94s: filter(type2:id1), info = 502.04 7 706 8 cuda: 100,
1m 24.89s: ------ mobile work failed(504.00 0 filter(type2:id1), info = 502.04 7 706 8 cuda: 100,

) ------

Only when I use video decoder all on software, it works.
So I run the movie on video encoder SOFTWARE + CUDA. Takes about 3 hours (too long when I read people here have about 50 FPS, I got only 17), but again movie out of sync.
I don't tried with software cause it would take about 10 hours, too long for me.

Any ideas what I can do?

[IPopov50]

Any ideas what I can do?

Not much really. CUDA decoder unworkable is a known issue and devs are working on it - it's in release notes - do not use CUDA decoder. Otherwise, just wait for new release.... be patient.

[signals]

I just used it earlier today, it worked fine decoding h264, but windows had to restart the nvidia driver after closing DVDFab, it crashed.