cant load iron man 3

[mlguinn]

Only takes a few seconds and pops out

[october262]

Only takes a few seconds and pops out

you need to use version 9.0.6.3 or later with pathplayer set to "always enabled" v8.2.2.9 Qt will not work with this movie.

[Digidave]

you need to use version 9.0.6.3 or later with pathplayer set to "always enabled" v8.2.2.9 Qt will not work with this movie.

Not true. I used 8.2.2.9 to run Iron Man 3 without a hitch. As a matter of fact, I've been using 8.2.2.9 for every movie. I have been waiting for the one movie that doesn't work & have yet to run across it. Maybe I'm just very lucky.

[signals]

Iron Man 3 does not open correctly in v8.2.2.9. The disc opens but the size is reported as 0 MB. It may copy in some cases depending on the copy mode and disc version.

[linjec]

I used 8.2.0.8 for Iron Man 3. It also worked w/o a hitch. I use 8.2.0.8 for everything. Works great!

[Axel Slingerland]

Not true. I used 8.2.2.9 to run Iron Man 3 without a hitch. As a matter of fact, I've been using 8.2.2.9 for every movie. I have been waiting for the one movie that doesn't work & have yet to run across it. Maybe I'm just very lucky.

I would say you definitely are lucky. I've been using 8.2.2.9 since it was released and have had several movies it wouldn't copy. Not like Iron Man 3 though. I had the same problem with Star Trek Into Darkness as well. It just ejected both disks after doing nothing. Fab 9 copied both just fine though.